Stick Connections - Miller Syncrowave 250 DX Technical Manual

3-13. Stick Connections

Tools Needed:
11/16, (21 mm), 3/4 in
Syncrowave 250 DX
4
1
3
2
Y Turn Off power before mak-
ing connections.
1 Work Weld Output Terminal
Connect work lead to work weld
output terminal.
2 Electrode Weld Output
Terminal
Connect electrode holder to elec-
trode weld outout terminal.
3 Remote 14 Receptacle
If desired, connect remote control
to Remote 14 receptacle.
4 Output Selector Switch (See
Section 4-2)
Switch is shown in DCEP (direct
current electrode positive) position
for Stick DCEP welding. For front
panel control dispay, see Section
3-14. For Stick AC welding, place
switch in AC position (see Section
4-2). For Stick AC front panel con-
trol dispay, see Section 3-15.
802 733-C
TM-359 Page 21