5.3
Remove the cover
When the cover is removed it is easier to install the inline feeder cable.
1
90°
1
Rotate the cover 90°. Make sure the cover is not locked.
2
Slide the cover to the rear side. The hinges should pass the locking features that keep the hinges in place.
3
Now the cover can be taken off.
5.4
Remove the tray
To easier access the bottom of the closure to install the inline feeder cable, the tray(s) can be removed as well.
1
1
Push the tabs that lock the tray downwards.
2
Rotate the tray open 90°.
3
Pull the lock forward to be able to release the tray.
Note:
Note that the tray is lifted to the top position in the hinges to be removed.
4
4
Slide the tray to the left to release it from the hinges.
5
Tray fully removed. The bottom is now accessible to install the inline feeder cable.
Note:
The components mounted in the bottom are application dependent. The images are showing a router island
in the bottom.
2
2
90°
5
© 2022 CommScope, Inc. All Rights Reserved
90°
page 6 / 14
3
3