Interface Requirement; Standard Accessories - ASD FieldSpec 3 User Manual

www.asdi.com
1.1.4

Interface Requirement

Note:
1.1.5

Standard Accessories

ASD.Document 600540 Rev. C
The FieldSpec spectroradiometer communicates using a 10/100 Base T
Ethernet card. The FieldSpec spectroradiometer works fine with the Ethernet
connection provided on many laptop computers.
The 802.11b wireless Ethernet cards within the FieldSpec spectroradiometer
and instrument controller can allow communication distances of 30-40 m
(100-150 ft). ASD tests the wireless communication up to 30 m (100 ft).
However, obstructions or radio frequency interference in close proximity can
cause loss of communication or significantly shorten the communication
range.
For information about configuration of the Ethernet card and cable, please
refer to the Installation Manual.
• FieldSpec Instrument
• FieldSpec® 3 User Manual (PDF on Flash Drive)
• Auxilliary Power Supply 18 V.
• NiMh Battery (12 V, 9000 mA hour)
• Battery charger
• Power adapter with 6 m (20 ft) cord for automobile cigarette lighter.
When using this adapter, the vehicle's engine should be turned off,
because electromagnetic fields from the engine can generate noise in the
acquired signals.
• RJ45 CAT 5e UTP Ethernet, Shielded, Crossover Cable 1.4 m (5 ft)
• Instrument Controller: ASD-approved laptop computer (not included with
desktop instruments)
3
• RS Software Pack
• 64 MB (min.) Flash Drive Memory USB Flash Drive
• FieldSpec Pistol Grip
• Remote trigger with LED indications and velcro pads.
• Pro Laptop Carrier
• Mylar Reference
• Fiber optic inspection magnifier
• Ergonomic Pro-Pack with built-in rain protector, sample storage
compartment, instrument controller (laptop) compartment, snap-on belly
board for laptop, and two battery pouches designed for the hip belt.
4
Chapter 1 Introduction
FieldSpec® 3 User Manual