Table of Contents
Advertisement
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in
length.
b,
If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE
POWER CORD. Using the allen wrench, turn both
rear rolleradjustment boltscounterclockwise,1/4 of a
turn. When the walking belt is properlytightened, you
should be able to lift each side of the walking belt 3 to
4 inches off the walking platform.Be careful to keep
the walking belt centered. Plug in the power cord, in-
serf the key and run the treadmill for a few minutes.
Repeat untilthe walking belt is properlytightened.
Rear Roller Adjustment Bolts
c. If the walking belt stillslows when walked on, please call our toll-free HELPLINE.
PROBLEM: The walking belt Is off-center
SOLUTION: a. If the walking belt has shifted to the left, first remove
the key and UNPLUG THE POWER CORD. Using the
allen wrench, turn the left rear roller adjustment bolt
clockwise, and the right bolt counterclockwise,1/4 of a
turn each. Be careful not to overtighten the walking belt.
Plug in the power cord, insertthe key and run the tread-
millfor a few minutes. Repeat untilthe walking belt is
centered.
b. If the walking belt has shifted to the right, first re-
move the key and UNPLUG THE POWER CORD.
Using the allen wrench, turn the left rear rolleradjust-
ment bolt counterclockwise,and the right bolt clockwise,
1/4 of a turn each. Be careful not to overtighten the
walking belt. Plug in the power cord, insertthe key and
run the treadmillfor a few minutes. Repeat until the
walking belt is centered.
PROBLEM: The walking belt slips when walked on
SOLUTION: a. If the walking belt slipswhen walked on, first remove
the key and UNPLUG THE POWER CORD. Using the
allen wrench, turn both rear rolleradjustment bolts
clockwise, 1/4 of a turn. When the walking belt is cor-
rectly tightened, you shouldbe able to lift each side of
the walking belt 3 to 4 inches off the walking platform.
Be careful to keep the walking belt centered. Plug in the
power cord, insertthe key and carefullywalk on the
treadmill for a few minutes. Repeat until the walking belt
is properlytightened.
a
PROBLEM: The Incline of the treadmill does not change correctly or does not change when I-FIt.com
CD's and videos are played
SOLUTION: a. With the key inserted in the console, press one of the INCLINE buttons.While the Incline Is
changing, remove the key. After a few seconds, re-insert the key. The treadmillwill automati-
cally rise to the maximum inclinelevel and then return to the minimum level. This will recalibrate
the incline.
21
Advertisement
Table of Contents
