Table of Contents
Advertisement
Disassembly and Reassembly > Disassembly
(14) Link Bracket, Drive Block, and R Case (Figs. 5-3-16, 5-3-17, 5-3-18)
Link Bracket (a) (Fig. 5-3-16)
1) Remove two screws [K], and then remove the link bracket.
Drive Block (b) and R Case (c) (Figs. 5-3-16, 5-3-17, 5-3-18)
2) Remove screw [D].
3) Remove two screws [A] from the bottom of R case.
4) Remove two screws [D] from the rear of R case.
5) Remove screw [D] from front of R case.
6) Remove screw [D] from top of R case and then remove the drive block from R case.
Note:
Take care when handling the drive block: The drive block contains the disc drive unit, which is a
precision component. Do not subject the disc drive unit to impact, or allow dust to adhere to it:
Doing so could cause a fault.
Procedure and caution for reassembly
Be sure to attach the heat sink rubbers (d) when installing the frame: Forgetting to attach the heat
sink rubbers could cause a fault.
Fig. 5-3-16 Link Bracket, Drive Block, and R Case
(a) Link Bracket
(b) Drive Block
(c) R Case
(d) Heat Sink Rubbers
2 [D]
(c)
5 [D]
(a)
1 [K]
Fig. 5-3-17 Link Bracket, Drive Block, and R Case
[A] M1.7×4 (Black)
[D] M1.6×2.5 (Black)
[K] M1.6×2 (Gold)
Fig. 5-3-18 Link Bracket, Drive Block, and R Case
5 - 14
6 [D]
3 [A]
3 [A]
4 [D]
(b)
4 [D]
(d)
Advertisement
Table of Contents
