Camera Block; Disc Drive Unit And R Case - Hitachi DZ-GX3300E Service Manual

Disassembly and Reassembly > Disassembly

(13) Camera Block

1) Remove the screw [B].
Note:
Take great care when handling the camera
block: The camera block contains the lens unit,
which is a precision component. Subjecting the
lens unit to any impact, however slight, could
result in a fault.

(14) Disc Drive Unit and R Case

1) Disconnect the fl at cable.
2) Remove the two screws [A].
3) Remove the two screws [D], and then remove the disc drive unit (a).
Note:
The disc drive unit is a precision component: Take great care when handling it. Do not subject the
disc drive unit to any impact: Doing so could cause a fault.
Caution during disassembly and reassembly:
Be sure to paste the heat sink rubber (c): Neglecting this could cause a fault.
(a) Disc drive unit
(b) R case
(c) Heat sink rubber
(a) Camera block
(b)
1)
2) [A]
(a)
Fig. 5-3-14
5 - 12
[B] M1.7×2.5
Fig. 5-3-13
Pull out
(c)
3) [D]
[A] M1.7×4
(Silver)
[D] M1.7×4
(Black)
(Silver)
(a)
1) [B]