Hitachi DZMV380EAU Service Manual page 50

Troubleshooting > Self-Diagnosis Function and Troubleshooting
Error code Contents of problem
3122 Recording on DVD-RAM disc failed.
3126 Writing data file to disc failed.
3133
7601 It takes much more time than
necessary to process start or end of
recording (timeout error).
7890 Recording on DVD-R disc failed.
7791 Formatting DVD-RAM disc failed.
3105 When recording photo, writing data to
disc failed.
E000 Writing data to disc failed.
EC87 Abnormal stop during reading or
writing of data from/to disc.
F100 Buffer has overflowed during
recording.
F526 When starting recording, reading of
data file on disc failed.
F571 When recording photo, writing data to
disc failed.
F572 When recording video, writing data to
F573 disc failed.
F600 Backup error
F700 No response from disc drive even when
3 minutes has elapsed (drive timeout
error).
F924 Recording failed
FB24 Initialization at start of recording
failed.
FB34 While recording mode was being
transferred to recording pause, writing
data to disc failed.
FB44 During processing of buffer overflow
error, writing data to disc failed.
Table 4-4-1 Major Error Codes and Troubleshooting (2/2)
Troubleshooting
1) Set the power switch to "POWER OFF", reattach the
battery or AC adapter/charger, and then set the power
switch to "VIDEO" or "PHOTO" (disc).
Take care not to subject DZ-MV350E to impact or
vibrations at this time.
2) Set the power switch to "POWER OFF", remove the
disc and check whether or not it is dirty, scratched or
distorted. If it is dirty, clean it referring to the next
page, and then reload it. If it is scratched or distorted,
use another disc.
Then set the power switch to "VIDEO" or "PHOTO"
(disc).
3) Replace the disc without regard as to whether it is
dirty, scratched or distorted.
Format it again, or replace the disc.
1) Set the power switch to "POWER OFF", reattach the
battery or AC adapter/charger, and then set the power
switch to "VIDEO" or "PHOTO" (disc).
Take care not to subject DZ-MV350E to impact or
vibrations at this time.
2) Set the power switch to "POWER OFF", remove the
disc and check whether or not it is dirty, scratched or
distorted. If it is dirty, clean it, and then reload it. If it
is scratched or distorted, replace the disc.
Then set the power switch to "VIDEO" or "PHOTO"
(disc).
3) When using DVD-R disc:
Replace the disc without regard as to whether it is
dirty, scratched or distorted.
When using DVD-RAM disc:
Initialize the disc (deleting all data recorded on
disc), or replace the disc.
4 - 22