Intelligent Battery Function - Hubsan MINI User Manual

1.2.3 Intelligent battey functions
1.2.3 Intelligent battey functions
1) Powe display:
power.
2) Battey stoage potection:
days without any use, it will automatically turn into self-discharge mode to protect it-
self (there may be slight heating during discharging).
3) Balance Potection:
against deterioration.
4) Chaging tempeatue potection:
or above 40°C, it may be damaged. So the battery will not charge at these tempera-
ture values,
5) Ovechage potection:
Therefore when the charging current is too high, the battery will automatically stop
charging.
6) Ovechage potection:
the battery is fully charged, it will automatically stop charging.
7) Ove-dischage potection:
When the battery is not in use it will stop supplying power at a certain voltage. While
the over-discharge protection will not allow the Drone to start.
8) Shot cicuit potection:
to protect itself.
9) Cell damage detection:
unbalanced, the damage will be indicated.
10) Hibenation Potection:
enter a non-operational state after 20 minutes to maintain charging. When the battery
charge is less than 5%, if the Drone is stationary but not turned off, it will automati-
cally turn off. If the Drone is turned off, the battery will automatically enter the sleep
state to avoid excessive discharge. At this time, short press the off switch, the battery
can be reactivated by charging it.
11) Communication:
power, in real time through the communication interface located on the battery, fur-
thermore the information also appears on the display of the radio control.
The battery has a power indicator, which can display the battery
After the battery is fully charged and stored for 10
The battery automatically balances the cell voltage to protect
High current charging will seriously damage the battery.
Overcharging will seriously damage the battery. When
Over-discharge will seriously damage the battery.
When the battery detects a short circuit, it will cut off
When the battery is detected to be damaged or severely
When the Drone is powered on but in standby, it will
the aircraft can send information, such as battery voltage and
Short press to check battery level, it will automatically turn
off after 3 seconds.
First short press and then long press to switch on/off, the in-
dicator light turns on or off.
When the battery temperature is below 5°C
BATTErY BUTTON
10