Ht011 Function Breakdown - Hubsan H123D X4 JET User Manual

2.2.2 HT011 Function Breakdown

No. Key/Button/Switch
Throttle
(1)
/Rudder Stick
Elevator
(2)
/Aileron Stick
Throttle/Aileron
1
Stick
Elevator
2
/Rudder Stick
3 Binding
4 Power Switch
5 Photo
6 Video
Normal
7
/Expert Mode
8
Flight Mode
9 LED ON/OFF
10 Status LEDs
11 Micro-USB Port
12 Clear Screen
Push the stick forward or backward and the quadcopter will ascend
or descend (respectively). Push the stick left or right and the
quadcopter will rotate counterclockwise or clockwise (respectively).
Push the stick forward or backward and the quadcopter will fly
forwards or backwards (respectively). Push the stick left or right and
the quadcopter will fly left or right (respectively).
Push the stick forward or backward and the quadcopter will ascend
or descend (respectively). Push the stick left or right and the
quadcopter will fly left or right (respectively).
Push the stick forward or backward and the quadcopter will fly
forwards or backwards (respectively). Push the stick left or right and
t h e q u a d c o p te r w i l l ro t a te c o u n te rc l o c k w i s e o r c l o c k w i s e
(respectively).
Power on the transmitter while holding down the binding button.
Long press to power on/power off the transmitter.
Short press to take photos.
Short press to start and end video recordings.
Normal Mode: Throttle 100%, Elevator 60%, Aileron 60%,
Rudder/Yaw 60%;Expert Mode: Throttle 100%, Elevator 100%,
Aileron 100%, Rudder/Yaw 100%
Manual Mode: Operating under full stabilization- no acro is
possible.
Sport Mode: Operating under partial stabilization- no acro is
possible, but flight is relatively flexible.
Acro Mode: Operating with no stabilization- acro is possible and
flight will be very flexible.
(Novice pilots are recommended to use Manual Mode).
Short press to turn on aircraft LEDs and short press again to shut off
LEDs.
Battery Voltage LED (low power): If the aircraft voltage is at or
below 6.8V, the LED will slowly flash. If the voltage is above 6.8V, the
LED will be solid.
2.4G Status LED: If the transmitter is not paired/connected to a
device via the 2.4G frequency, the LED will be completely off. If the
transmitter is paired/connected to a device via the 2.4G signal, the
LED will be solidly lit.
Not supported for charging or upgrading.
When paired with the HS001 display, push upwards to clear the
screen; push downwards to show content.
13
Function