Remote Control Option; Lifting The Load - Applying Suction - probst 5272.0006 Operating Instructions Manual

Remote control option

The radio remote control has been tested and complies with the statutory limits for a Class B digital device
according to Part 15 of the FCC Regulations. These statutory limits should properly protect against harmful
interference in residential areas.
The radio remote control produces, uses and emits high frequencies that could disrupt radio traffic if not
used in accordance with these instruction.
However, there is no guarantee that interference will not occur in a particular installation. In case the radio
remote control causes radio or TV reception interference that
can be determined by turning the device off and on, it is recommended to resolve the interference using
one or more of the following measures:
•
Realign reception antennae or change their positioning.
•
Increase the distance between radio remote control and receiver.
•
Consult a dealer or experienced radio/TV specialist.
CAUTION
Lifting the load – applying suction
WARNING
31/44
Risk of injury from uncontrolled movement of the lifting device
►
Always keep the path and load in eyesight.
Only work when you have a good view of the entire working area.
►
Ensure that no one is within the danger zone before releasing the load.
Risk of injury from falling objects
►
Secure load using load safeguard chain before transporting.
►
Only lift a load with a minimum vacuum value of -0.6 bar (manometer in
green zone). Otherwise, the holding force is not sufficient.
►
Do not suddenly lift or lower the load.
►
Loads with moist, wet, oily, icy, dirty, dusty surfaces or surfaces with
decreased friction must be cleaned before applying suction.
►
The maximum lift capacity of the individual suction plates must not be
exceeded.