Programmable Band-Scan From; The Keyboard Oo; Scan Direction; Scan Speed - Kenwood TM-3530A Instruction Manual

Lights during scan operation @ Select key mode.
FLOCK oNAR MICH
PHONE TONE VOICE
OOo
@ Press to release scanning. @ Press to start
{Scanning can also be re- scanning.
leased using the PTT
switch.)
@ Select the channel ta @ Set to memory
Lock outindicator be locked out. mode.
(cock "onan
Na OE
| By
PHONE TONE VC
OOC
@ A star * will appear on the @When the Lo] key is pressed
display when this key is again, the star * will disap-
pressed, indicating that pear and lockout will be re-
Jockout has been complet- _ leased.
ed.
18
4-5-2. Programmable band-scan from
the keyboard
@ Press the M.CH switch to select key mode. The
MEMORY CHANNEL selector lamp will go OFF.
@ Press the [SC] key to initiate scan operation. If scan is
initiated within the limits set in channel" d" and" U",
scan will proceed from the currently displayed fre-
quency (within the programmed limits}, in 5 kHz
steps. If you initiate scan outside the programmed
limits, scan will proceed outside the programmed
limits, in 5 kHz steps.
@ When the same frequency has been stored in both
memory "d" and memory " U". The radio will scan
the entire frequency range of the radio.
4-5-3. Scan direction
During scan operations you can reverse the direction of
scan with the UP and DWN pushbuttons on the micro-
phone. Pressing the DWN key causes scan to proceed
down in frequency. Pressing the UP key causes scan to
increase in frequency.
4-5-4. Scan speed
Scan speed can be increased by holding either the UP or
the DWN key depressed, depending upon the desired di-
rection of scan.
4-5-5. Scan lockout (Skip)
This transceiver has a scan lockout function which al-
lows you to temporarily skip unwanted memory channels
during memory scan.
@ Press the M.CH switch to select the memory mode.
(The MEMORY CHANNEL selector will light.)
@ Select the memory channel to be skipped by using the
MEMORY CHANNEL selector.
@ Press the key and a star * appears to the left of
the memory channe! number.
@ Repeat steps @ and @ to lockout any unwanted
memory channels.
To cancel channel lockout, select the memory channel
to be restored, and press the [LO| key. The star will
disappear.
4-5-6. Scan release
Scanning can be released by any one of the following
operations: Select the most convenient.
@ Press the [C| key.
@ Press the PTT switch once.
@® Turn power OFF.
@ Set the PRIO switch to ON.
® Set the F.LOCK switch to ON.
Al PRO)
4-6. REPEATER
4-6-1. Automatic repeater offset
The standard ARRL and ITU Region 1 Band Plan, as far as
TX offsets is concerned, has been pre-programmed into
the TM-3530A/2570A/2550A/2550E/2530A. This
4-5-7. Priority channel scan (Alert)
(With the TM-3530A}
a Se
{With the TM-2570A/2550A/2530A)
(With the TM-2550E)
220,000 223940 224995
144.00 : 146.00