Default Settings - XiNCOM Twin WAN XC-DPG502 User Manual

Twin WAN Series – User Guide | v1
Front Panel Status & Error Conditions
LED Action
WAN1 LINK/ACT & 10M/100M LEDs flash alternatively.
WAN1 LINK/ACT & 10M/100M LEDs flash concurrently.
WAN1 LINK/ACT & 10M/100M LEDs solid On
WAN2 LINK/ACT & 10M/100M LEDs solid On
LAN1 LINK/ACT & 10M/100M LEDs solid On
Twin WAN Gateway – Rear Panel
Connect the primary Broadband Modem to WAN 1 and the second
WAN Ports -
Broadband Modem on WAN 2.
LAN Port - Connect the PCs to these ports. Both 10BaseT and 100BaseT
connections can be used simultaneously.
Note: Any port will automatically operate as an "Uplink" port if
required. Use a standard RJ-45 Ethernet cable to connect to any port
to another hub or switch.
Press the Reset button once for a warm reboot. To reset the Twin
Reset Button -
WAN Gateway to default settings, press and hold the reset button for
30 seconds.

Default Settings:

When the Twin WAN Gateway has finished booting, all configuration settings will be set
to the factory defaults, including:
• The IP Address is set to its default value of 192.168.1.1 with a Network Mask of
255.255.255.0
• DHCP Server is enabled
• User Name: admin
• Password cleared (no password)
Copyright © 2005 WINS International, LLC dba XiNCOM | All rights reserved.
Condition
Firmware Download in progress.
MAC address not assigned.
SDRAM error
Timer/Interrupt error
LAN/WAN error
8