XiNCOM Twin WAN XC-DPG502 User Manual page 50

Twin WAN Series – User Guide | v1
Using Remote Web-based Setup
To connect to the Twin WAN Gateway from a remote PC via the Internet:
1. Ensure that both your PC and the Twin WAN Gateway are connected to the Internet.
2. Open a Web Browser. (MS Internet Explorer, Firefox, Netscape, Safari, etc.)
3. In the Address bar enter:
http:// (Internet IP Address of the Twin WAN Gateway)
The Port number is also required. (After the IP Address, enter ":" followed by the
port number)
e.g.: http://123.123.123.123:8080
NOTE:
This example assumes the WAN IP Address is 123.123.123.123, and the port number
is 8080. If you are using the Dynamic DNS feature, you can connect using the
domain name allocated to you.
e.g.: HTTP://my_domain_name.dyndns.org:8080
External Filter Configuration
These settings determine whether or not the Twin WAN Gateway will respond to ICMP
(ping) requests received from the WAN port. When the Block Selected Packet Types is
enabled, the selected packet types are blocked.
DNS Loopback
Some servers on a LAN and their domain names have already registered on a public
DNS. To avoid DNS loopback problem, enter the following fields:
•
Domain Name – Enter the domain name specified by you for local host/server.
•
Private IP – Enter the private IP address of your local host/server.
Interface Binding
This option allows SMTP Binding to a specific WAN port. This applies only when using
E-mail accounts from different ISPs on each port. Some ISPs configure their E-mail
Servers so they will not accept E-mail from IP addresses not allocated by themselves. If
you are using accounts from different ISPs, sending E-mail over the wrong port may
result in non-acceptance of the mail. In this case, you can use these settings to correct the
problem.
Copyright © 2005 WINS International, LLC dba XiNCOM | All rights reserved.
49