Rack Id Rotary Hex Switch Position; Configure The Dante System As Follows - Cadac C Series Hardware Overview

Rack ID Rotary Hex Switch Position

Select address 2 on the CM-DT64 rotary Hex switch
NOTE: Always set the rack address while the unit is OFF or restart the unit if changed while it was ON.
Check Power switch LED is illuminated
Check all BNCs illuminated
Check that the MegaCOMMS LEDs Tx and Rx are illuminated
Check that Dante Port A Ethernet LEDs are active

Configure the Dante system as follows:

CM-DT64, MegaCOMMS address
Dante controller, Device view, Device config.
Dante controller, Routing map*
Dante controller, Clock Status, Primary status
Apply analogue audio source to local Mic IN on the console
Connect speaker to local Line OUT on the console
Select CH1 routing on the console GUI:
Input set to analogue audio source port
Send set to Dante 1 port 1
Select CH1 routing on the console GUI
Input set to Dante1 port 33
Send set to speaker port
At this point an audio path should now exist between the two analogue ports on the console. This will
be utilising both Dante Port A and B on the CM-DT64.
*Important Note: Where audio is routed from Port A to B this method is the only way the audio
loopback will work on the CM-DT64. You cannot connect between channels on the same ports!!!!
2 (only one CM-DT64 in the system)
Port A – 96 kHz, Port B – 96 kHz
Connection 1 Port A CH1 to Port B CH1
Port A or B operating as WORD CLOCK
CM-DT64_26-05-2023_Iss-1.docx
Page. 27 / 36