Cadac C Series Hardware Overview page 17

7. WC: Word Clock status. These LEDs no longer function. Status is shown in the Dante
Controller software.
8. SYNC: Synchronisation status. These LEDs no longer function. Status is shown in the Dante
Controller software.
9. Word Clock IN / Word Clock OUT: Word clock IN no longer is active. Word clock OUT - on
BNC connectors for 75 ohm co-axial cable - to act as the synchronisation of the digital signal
within the network.
10. 75 ohm switch: This switch no longer functions as it applies to the Word clock IN connector.
11. Network: RJ45 Ethernet port for updating the unit's firmware. This is a standard PC network
Gigabit Ethernet port.
12. PSU indicators: LEDs indicate the ON status of each of the two internal power supplies.
CM-DT64_26-05-2023_Iss-1.docx
Page. 17 / 36