Setting Up The Cm-Md64 For A Madi Network; Front Panel Dip Switch Settings; Important Notes - Cadac CM-MD64 Hardware Overview

Setting up the CM-MD64 for a MADI Network

The following section provides a guide on how to set up the Cadac CM-MD64.

Front Panel Dip Switch Settings

The table below shows how the unit can be configured via from Configuration DIP switch [3] on the front
panel:
DIP Switch
DIP 1
DIP 2
DIP 3
DIP 4
DIP 5

Important Notes

•
DIP switches 6, 7, 8 are set to OFF
•
Definitions of EXTERNAL / INTERNAL operation above DO NOT relate to MegaCOMMS. The
CM-DM64 will always follow MegaCOMMS when connected to a Cadac digital console.
•
One MADI port Tx connection may not be routed to a Rx connection from the same port
Mode
MADI Channel / Stream 1
MADI Channel / Stream 2
Clock Speed
SYNC
SYNC Source
CM-MD64_24-05-2023_Iss-1.docx
Page. 22 / 31
ON OFF
COAX RX OPTICAL RX
COAX RX OPTICAL RX
96 kHz 48 kHz
EXTERNAL INTERNAL
WORD
MADI
CLOCK