Channel Configurations Available - Cadac C Series Hardware Overview

Channel Configurations Available

Channel configuration per Dante port dependent on sample rate selected:
Fsample
44.1 / 48 kHz
88.2 / 96 kHz
Both Dante cards must be set to the same Word clock rate - even if only one card is being used.
Below are the front panel status LEDs that indicate the Word clock rate of the CM-DT64:
MegaCOMMS to Dante audio channel connections are configured on the routing page of the Dante
Controller.
Dante Port A must always be connected when using CM-DT64.
*
MegaCOMMS
Port A I/O
mapping
64 1-64
32 1-32
44.1 kHz
48 kHz
88.2 kHz
96 kHz
CM-DT64_26-05-2023_Iss-1.docx
Page. 24 / 36
MegaCOMMS
Port B I/O
mapping
Not used
32 33-64
-