Olimpia splendid Bi2 WALL TR 1000 Instructions For Use And Maintenance Manual page 83

7.12.4 - Water probe inhibition
If a particular system requires it, it is possible to inhibit the control of the unit on un-
suitable water temperature.
- Disconnect the unit from the power supply.
- Disconnect the battery probe from the connector X4
- Switch on the unit and wait that the alarm "E3" appears on the display.
- Press keys "T2" and "T3" simultaneously for at least 10 seconds, at this point the
alarm is disabled and the display shows the desired temperature.
To reactivate the control of water temperature (from disconnected machine), it is
necessary to reconnect the probe.
7.13 - OPERATION WITH TIMER (delayed switching on and switching
off)
This mode allows to program the unit switching on and switching off
The delay time can be set, activated and cancelled from the remote controller.
7.13.1 - Setting of the switching on timer from remote controller
a. After switching on the unit, select the operating mode,
desired temperature and fan speed with which the unit will
reactivate at the programmed switching on.
Then, set the machine to Stand-By mode.
b. Press key "B8" to set the desired delay (from 1 to 24 hours) after
which the unit will switch on starting from timer confirmation.
c. If no key is pressed within 5 seconds, the timer setting
function will end automatically.
d. The remote controller display shows the countdown for
switching on while the display of the fan coil shows the
message "tI".
Once the set time passes, the unit will start with the last
selected settings.
7.13.2 - Setting of the switching off timer from remote controller
a. With the unit set to any operating mode, press key "B9" to
set the desired delay (from 1 to 24 hours) after which the
unit will switch off starting from timer confirmation.
b. If no key is pressed within 5 seconds, the timer setting
function will end automatically.
c. The remote controller display shows the countdown for
switching off while the display of the fan coil shows the
message "tI".
ON
OFF
0 h
OFF
ON
0 h
Bi2 WALL TR 1000/1200/1400
6.0h
Start
6.0h
3.0h
Stop
3.0h
EN - 35