Olimpia splendid Bi2 WALL TR 1000 Instructions For Use And Maintenance Manual page 82

If the fan is switched off while the flap is set to swing mode, the
swing stops and restarts when the fan is switched on again.
This function can only be activated/deactivated from the remote
controller.
7.12 - SPECIAL FUNCTIONS
7.12.1 - Air sampling
In heating or cooling mode and with ambient temperature higher or lower than the
desired value, the fan is periodically powered for 1 minute at minimum speed. This
way, the system is able to adequately keep temperature in the room under control
and to reactivate faster in case of need.
7.12.2 - Commands lock
To lock the keys on board the machine, keep keys "
neously for 5 seconds.
The activation of the function is verified by the visualization of (BL) on the display
every time any key is pressed.
This function can only be activated/deactivated from board the
machine.
7.12.3 - Water not suitable
The effective operation of the appliance in cooling or heating mode is always con-
ditioned by temperature of water circulating inside the system. If water temperature
does not reach a value suitable for the set mode, so if water is too hot in cooling
mode or too cold in heating mode, the fan motor remains off and the indicator of the
current mode (A5) blinks.
- The function is active in cooling mode if the unit is not thermostatic and if water
temperature in the battery is higher than 20°C from more than 5 minutes.
The unit immediately resumes normal operation of one of the two conditions is
not met anymore.
- The function activates in heating mode if the unit is not thermostatic and if water
temperature in the battery drops under 30°C (the fan stops immediately).
In heating mode, the unit restarts normal operation only if temperature is higher than
30°C for at least 30 seconds
EN - 34
" (T1) pressed simulta-