Table of Contents
Advertisement
❼
❻
❹
❺
3) The pedal is operated in the following four steps:
a. The machine runs at low sewing speed when
you lightly depress the front part of the pedal. ❹
b. The machine runs at high sewing speed when
you further depress the front part of the pedal. ❺
(If the automatic reverse feed stitching has been
preset, the machine runs at high speed after it
completes reverse feed stitching.)
c. The machine stops (with its needle up or down)
when you reset the pedal to its original position.
d. The machine trims threads when you fully de-
press the back part of the pedal. ❼
* When the auto-lifer (AK device) is used, one
more operating switch is provided between the
sewing machine stop switch and thread trimming
switch. The presser foot goes up when you light-
ly depress the back part of the pedal ❻ , and if
you further depress the back part ❼ , the thread
trimmer is actuated.
4) Reverse feed stitching at the beginning of sew-
ing, reverse feed stitching at the end of sewing
and various sewing patterns can be set on built-
in panel ❽ of the machine head.
5) After the completion of sewing, check to make
❽
sure that the sewing machine has stopped.
Then, press power switch ❶ or ❷ (or turn EU-
type power switch ❸ ) to turn it OFF.
In the case the machine is not used for
a long time, remove the power plug from
the plug receptacle.
– 29 –
Advertisement
Table of Contents
