Factory Default; Reboot - Planet IXT-900 Series User Manual

4.7.1.2 Factory Default

You can reset the configuration default of the switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in
to reset the configuration to Factory Defaults.
After the "Restore" button is pressed and rebooted, the system will load the default IP settings as follows:
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
The other setting value is back to disable or none.
。
To reset the GS-4210 802.3BT PoE++ Series to the Factory default setting, you can also press the
hardware reset button at the front panel about 10 seconds. After the device be rebooted. You can login the
management WEB interface within the same subnet of 192.168.0.xx.

4.7.1.3 Reboot

The Reboot button enables the device to be rebooted from a remote location. Once the Reboot button is pressed, user has to
re-login the Web interface for about 30 seconds. The Reboot button is shown in
Figure 4-7-2 Factory Default Page Screenshot
Figure 4-7-3 Reboot Button
165
User's Manual of IXT-900 Series
Figure 4-7-2
Figure 4-7-3 and clicks to reboot the system.
appears and clicks