Table of Contents
Advertisement
[J]
Front cover
Open this front cover when operating the POWER OFF/RESET
switch
[ill
or the DIP switches
~-Q]
during initial setting, or using the
floppydisk drive.
rn
POWER switch
Push to turn on the unit. Keep it depressed for more than two
seconds until the POWER indicator lights up.
You cannot turn the power off with this switch. To turn the power off,
use the appropriate ROM monitor system or operating system
command.
[}] POWER indicator
Lights up green when power to the unit is on.
[ ] NETWORK indicator
Lights up orange when the Ethernet controller receives or transmits a
packet.
[]] DISK indicator
Lights up red when the processor is accessing the built-in hard disk
or the external storage device connected to the SCSI bus.
[ill
Floppydisk eject button
Push to eject a floppydisk from the floppydisk drive. For inserting and
ejecting floppydisks, follow the instructions of the software in use.
For details, refer to your software manual.
[}] 3.5-inch floppydisk drive
Floppydisks are inserted into this slot.
rn
Floppydisk IN-USE indicator
Lights when data on the inserted floppydisk is accessed. Do not
eject the floppydisk while this indicator is lit. Data stored on the
floppydisk may be destroyed.
[fil
POWER OFF/RESET switch
Used to forcibly turn off power to the unit. In normal use software
commands should be used to turn off power to the unit.
To reset the CPU, push this switch while holding down the POWER
switch
rn.
After releasing this switch, keep the POWER switch
depressed (for about two seconds) until the POWER indicator lights
up again.
[!QI
DIP switches
Set these switches to designate the type of the connected display,
the OS booting device, and the starting program at power on. Refer
to page 1-9 and 1-10 for setting instructions.
NWS-1510/1530/1580
1-7
Advertisement
Table of Contents
