Sony NWS-1510 Service Manual page 118

4 - 3 - 16. Dip Switch Command
This command tests whether the DIP switch settings can
oe read properly by asking the operator to set them in speci-
fied ways.
If the
-#
option is used with a value of 2 or above, the
DIP switch status is displayed each time a switch is turned
ON or OFF.
diag>
dipsw -v
DIP-SWITCH CHECK [ 1 =ON I 0 =OFF I l =DON'T CARE]:
Set DIP-SWITCH = 11111111 and hit <R.ETURH> key
Set DIP-SWITCH = 01111111 and hit <R.ETURH> key
Set DIP-SWITCH = 00111111 and hit <R.ETURH> key
Set DIP-SWITCH = 00011111
and hit <RETURN> key
Set
DIP-SWITCH = 00001111 and hit <RETURN> key
Set DIP-SWITCH = 00000111
and hit <RETURN> key
Set DIP-SWITCH = 00000011 and hit <RETURN> key
Set DIP SWITCH as before [ 00000111 ] and hit <RETURN> key (•)
diag> !!
-3
dips-w
-v -3
DIP-SWITCH CHECK [ 1 =ON/ 0 =OFF I l =DON'T CARE]:
Read DIP-SWITCH = 10000111 (••)
Read DIP-SWITCH = 10100111 (••)
Read DIP-SWITCH = 10101111 (••)
Set DIP SWITCH as before [ 00000111 ] and hit <RETURN> key (•)
diag>
Notes:
*
Set DIP switches as they were before tne check.
OK
OK
OK
OK
OK
OK
OK
**
A DIP switch was turned ON or OFF.
(The display differs
depending on the current status.)
4 - 3 - 17. Floppy Disk Command
This command is used to test the floppy disk drive. Two
formatted diskettes, one 2DD and one 2HD are required.
Neitner disk should be write-protected. To format the floppy
disks, either use the metnoJ descriued among the options
below or use the OS format command.
4-26
NWS-1510/1530/1580