Configuring The Pulse/Frequency; Switch Output - Endress+Hauser Proline Prosonic Flow G 300 Operating Instructions Manual

Proline Prosonic Flow G 300 HART
Parameter
Operating mode
Endress+Hauser
10.4.7 Configuring the pulse/frequency/switch output
The Pulse/frequency/switch output wizard guides you systematically through all the
parameters that can be set for configuring the selected output type.
Navigation
"Setup" menu → Advanced setup → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
Parameter overview with brief description
Description
Define the output as a pulse, frequency or

switch output.

Configuring the pulse output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
Terminal number
Signal mode
Assign pulse output
Pulse scaling
Pulse width
Failure mode
Invert output signal
Selection
• Pulse
• Frequency
• Switch
Commissioning
→  87
Factory setting
Pulse
→  88
→  88
→  88
→  88
→  88
→  88
→  88
→  88
87