Draper Exterior Motorized FlexShade XL Instructions Installation & Operation
Draper Exterior Motorized FlexShade XL Instructions Installation & Operation

Draper Exterior Motorized FlexShade XL Instructions Installation & Operation

Outdoor shading system with smooth, quiet operation and independent control
Hide thumbs Also See for Exterior Motorized FlexShade XL:

Advertisement

Quick Links

Exterior Motorized FlexShade
Outdoor shading system with smooth, quiet operation and independent control

Overview - Components

EXT FLEX XL MON
E N D
C A
P
CABLE GUIDE
(Wall Mount shown)
Contents
Overview - Components ...............................................................................................1
Section 1 - Preparation for Installation .....................................................................3
Section 2 - Mounting Headbox with Brackets ........................................................3
PLEASE READ - Important Installation Information ................................................4
Section 3 - Installing Side Channels Option .............................................................4
Section 4 - Installing Cable Guides Option ...............................................................6
XL
®
TOOLS REQUIRED
PENCIL
LEVEL
HARDWARE
CRIMPING TOOL
CAUTION
understand
all warnings
before beginning
installation.
Section 5 - Securing Guide Cable ..............................................................................8
Section 6 - Cable Exit ...................................................................................................9
Section 7 - RF Remote Programming Instructions ...............................................10
Section 8 - Limit Switch Adjustments .....................................................................11
Section 9 - Complete Electrical Connection ..........................................................11
Section 10 - Assembled Dimensions: Front View ..................................................12
Section 11 - Dimensions: Side View .........................................................................14
Section 12 - Dimensions: Components ...................................................................16
If you have any difficulties installing or servicing your
Exterior Motorized FlexShade
Draper, Inc. | 411 S. Pearl St. Spiceland, IN 47385
© 2024 All Rights Reserved
INSTRUCTIONS
INSTALLATION & OPERATION
LASER LEVEL
TAPE MEASURE
POWER DRILL
WIRE STRIPPERS
PLIERS
(by others)
HEX WRENCH
NOTE: Draper
recommends
®
the 32-VC:VG Crimping
Tool available from
www.nicopress.com
PERSONNEL
REQUIRED
Read and
1
XL, call your dealer or Draper, Inc.
®
draperinc.com | 765.987.7999 | 800.238.7999
|
FORM: Ext_FSMO_XL_Inst24
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Exterior Motorized FlexShade XL and is the answer not in the manual?

Questions and answers

Summary of Contents for Draper Exterior Motorized FlexShade XL

  • Page 1: Table Of Contents

    If you have any difficulties installing or servicing your Exterior Motorized FlexShade XL, call your dealer or Draper, Inc. ® Draper, Inc. | 411 S. Pearl St. Spiceland, IN 47385 draperinc.com | 765.987.7999 | 800.238.7999 FORM: Ext_FSMO_XL_Inst24 © 2024 All Rights Reserved...
  • Page 2: Please Read - Important Safety & Installation Information

    Most standard Draper fabrics may be cleaned at the window by vacuuming with a soft brush attachment. They also may be cleaned by using a sponge or soft cloth and mild solution of warm telescoping.
  • Page 3: Section 1 - Preparation For Installation

    Exterior Motorized FlexShade ® page 3 of 16 MOUNTING 1 " Section 1 - Preparation for Installation BRACKET Caution: Before mounting shades, verify measurements on carton (44 mm) label provided with shade, and ensure unit is installed at correct width. Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
  • Page 4: Please Read - Important Installation Information

    Exterior Motorized FlexShade ® page 4 of 16 PLEASE READ - Important Installation Information WARNING: Fastener strength and fastener spacing are crucial for unit to operate correctly and withstand wind load. Secure Side Channel to structure with appropriate fasteners spaced NO MORE THAN 24" apart.
  • Page 5 Exterior Motorized FlexShade ® page 5 of 16 Wall Mounting Wall Mounting Jamb Mounting Jamb Mounting Mark and drill Side Channels at desired mounting points on wall or jamb. Caution: DO NOT drill through Side Channel Guide! Please Note: Secure Side Channel to structure with appropriate fasteners spaced NO MORE THAN 24"...
  • Page 6: Section 4 - Installing Cable Guides Option

    Exterior Motorized FlexShade ® page 6 of 16 Section 4 - Installing Cable Guides Option Determine appropriate mounting location of Mounting Brackets. Ensure that, CAUTION: DO NOT remove Fascia or once attached, cables will be Roller Assembly, or disassemble unit. plumb and parallel below each cable attachment point.
  • Page 7 Strip cable to mark other end. (Deck mount made in Step 4. option shown). Crimp the barrels Trim excess cable approximately 1/ 8 " as desired. (3mm) above mark. PLEASE NOTE: Draper recommends ® 32-VC:VG Crimper, available from www.nicopress.com...
  • Page 8: Section 5 - Securing Guide Cable

    Exterior Motorized FlexShade ® page 8 of 16 Section 5 - Securing Cable Guide Capture Hem Bar of shade and pull cable down through Cable Mounting Bracket. (Deck mount option shown) Pull cable down through Cable Mounting Hole on Headbox Endcap, until crimped barrels are resting on Cable Mounting Hole on...
  • Page 9: Section 6 - Cable Exit

    Exterior Motorized FlexShade ® page 9 of 16 Section 6 - Cable Exit The Exterior Motorized FlexShade can be ordered with a cable exit pre-drilled in the top or back of the Headbox. If no cable ® exit is specified, the cable is routed down and out the fabric opening under the motor. Please Note: Right hand motor is shown.
  • Page 10: Section 7 - Rf Remote Programming Instructions

    Exterior Motorized FlexShade ® page 10 of 16 Section 7 - RF Remote Programming Instructions Please Note: The motor ships with no programming. Follow these instructions to program unit to the desired transmitter. 1. Select a transmitter channel to assign motor. Hold UP and DOWN buttons until motor jogs, then release.
  • Page 11: Section 8 - Limit Switch Adjustments

    (es) (es) wiring diagram, and wiring should comply with national and local electrical codes. DO NOT wire motors in parallel without written permission from Draper. All operating switches should be “off” before power is connected. Controls & System Overview Controls & System Overview...
  • Page 12: Section 10 - Assembled Dimensions: Front View

    Exterior Motorized FlexShade ® page 12 of 16 Section 10 - Assembled Dimensions: Front View Cable Guide Option Shade Width 1 " Fabric Width (30mm) Shade Headbox Height Height (184mm) Side Cable Headbox Height Length (127mm) 2 " (57mm) Hem Bar Length Deck Mounted Cable Guide option, Wall Mounted configured for Inside Mount.
  • Page 13 Exterior Motorized FlexShade ® page 13 of 16 IMPORTANT: Side Channels must be installed parallel, plumb, and square, with a tolerance of +/- 1/ 8 " (3mm) Side Channel Option Shade Width 2 " Fabric Width (53mm) Side Channel Length Shade Height Side...
  • Page 14: Section 11 - Dimensions: Side View

    Exterior Motorized FlexShade ® page 14 of 16 Section 11 - Dimensions: Side View Cable Guide Option " (8mm) 5" 5" (127mm) (127mm) 7 " 7 " (184mm) (184mm) 5" 5" SHADE (127mm) SHADE (127mm) HEIGHT HEIGHT Deck Mount Bracket Wall Mount Bracket CEILING MOUNT...
  • Page 15 Exterior Motorized FlexShade ® page 15 of 16 Side Channel Option See Section 3 on Page 4 for Side Channel mounting instructions. " (8mm) 5" 5" (127mm) (127mm) 7 " 7 " (184mm) (184mm) 5" 5" SHADE (127mm) (127mm) SHADE HEIGHT HEIGHT 1 "...
  • Page 16: Section 12 - Dimensions: Components

    Exterior Motorized FlexShade ® page 16 of 16 Section 12 - Dimensions: Components Angled Headbox Curved Headbox 5" 5" 5" 5" (127mm) (127mm) (127mm) (127mm) 5" 5" 5" 5" (127mm) (127mm) (127mm) (127mm) ANGLED ANGLED CURVED CURVED HEADBOX HEADBOX HEADBOX HEADBOX Ceiling Mounting Bracket Wall Mounting Bracket...

Table of Contents