Powering On The Machine; Network Connection - Xerox Phaser 4600DN User Manual

Getting Started

Powering on the Machine

The On/Off switch and the power inlet are at the rear of the machine.
1. Connect the AC Power Cord
power outlet. The power cord must be plugged into a
grounded power socket.
2. Press the ON/OFF
3. To power off, press the ON/OFF switch to the OFF (O)
position.

Network Connection

If the machine is to be network connected, follow these steps to connect the network cable.
1. Connect a 10/100/1000 BaseT Ethernet cable to the
Ethernet Port
3
2. Connect the other end of the cable to your network
port.
The machine will attempt to join the network (this
may take a few minutes).
To configure the Network Settings at the machine, refer to
Network Settings on page 80. For full network installation
instructions, refer to the
12 Xerox Phaser 4600/4620
User Guide
to the machine and a
1
switch to the ON (I) position.
2
at the rear of the machine.
System Administrator Guide.
2
1
3