Getting Started
Powering on the Machine
The On/Off switch and the power inlet are at the rear of the machine.
1.
Connect the AC Power Cord
power outlet. The power cord must be plugged into a
grounded power socket.
2.
Press the ON/OFF
3.
To power off, press the ON/OFF switch to the OFF (O)
position.
Network Connection
If the machine is to be network connected, follow these steps to connect the network cable.
1.
Connect a 10/100/1000 BaseT Ethernet cable to the
Ethernet Port
3
2.
Connect the other end of the cable to your network
port.
The machine will attempt to join the network (this
may take a few minutes).
To configure the Network Settings at the machine, refer to
Network Settings
on page 80. For full network installation
instructions, refer to the
12
Xerox Phaser 4622
User Guide
to the machine and a
1
switch to the ON (I) position.
2
at the rear of the machine.
System Administrator
Guide.
2
1
3