Paper Tray 2 And Paper Trays 3, 4, 5 And 6 (Optional) - Xerox Phaser 4600DN User Manual

4. Adjust the paper guide to the width of the stack of print
material. Ensure you have not loaded too much print media.
The stack should be under the Maximum Fill line.
5. After loading paper in the paper tray, set the paper size, type
and color using the control panel. Press OK to confirm the
settings or Stop to change the settings.
For instructions, refer to
6. When printing from your PC, ensure you select the Paper
button to specify the correct paper size, color and type. Not
confirming the paper details may result in printing delays.
If the paper does not feed well while printing, push the paper in manually until it starts feeding
automatically.

Paper Tray 2 and Paper Trays 3, 4, 5 and 6 (optional)

Acceptable print media for Paper Tray 2 is plain paper from 3.8 x 5.8" to 8.5 x 14" Legal (98.6 x 148.5
mm to 216 x 356 mm) and weighing between 16 lb and 43 lb (60 g/m² and 163 g/m²). Acceptable
print media for Paper Trays 3, 4, 5 and 6 is plain paper from 3.8 x 7" to 8.5 x 14" Legal (98.6 x 177.8 mm
to 216 x 356 mm) and weighing between 16 lb and 43 lb (60 g/m² and 163 g/m²).
Envelopes can be loaded in Paper Tray 2. If loading envelopes, remove any curl on the envelopes before
loading them. Prepare a stack of envelopes for loading by flexing or fanning them back and forth, a
maximum of 50 envelopes can be loaded.
For information about loading the High Capacity Feeder, refer to
page 58.
1. Open the paper tray.
The paper level indicator on the front of the tray shows the
amount of paper currently left in the tray. When the tray is
empty, the indicator of the bar is completely lowered.
2. Fan the paper and insert it into the tray. Do not fill above the
Maximum Fill Line
Note Paper Trays 2, 3, 4, 5 and 6 can hold a maximum of
520 sheets of 20 lb (80 g/m²) bond paper or 50 envelopes in
Paper Tray 2.
Tray Paper Settings
.
on page 61.
High Capacity Feeder (optional)
Paper and Other Media
Xerox Phaser 4600/4620
User Guide
on
57