Printer Power-On Procedure - Xerox DocuPrint 65 Operator's Manual

Operator Guide

Printer power-on procedure

DocuTech 65/DocuPrint 65
When the printer is on, the power-on/power-off indicator glows green.
The printer must be switched on by pressing a switch on the printer. The
printer cannot be powered on from the DocuSP Print Services interface that
runs on the controller. The printer power switch is shown in Figure 2-2.
Because this switch rocks back to its center position each time it is pressed in
either direction, you cannot determine whether the printer is on by looking at
the switch position.
To power on the printer:
1. Locate the white on/off switch on the right side of the printer.
2. Press the switch toward the back of the printer.
3. Confirm that the power-on/power-off indicator glows green.
Figure 2-2. Printer power-on
After powering-on, jobs will not print until the Fuser is ready and the network
connections are established. The system is usually ready for network printing
within 7 minutes.
Maintenance
2-3