Tray Guides And Loading Paper - Xerox DocuPrint 65 Operator's Manual

Operator Guide

Tray guides and loading paper

DocuTech 65/DocuPrint 65
Do not open a tray that is in use, a paper jam may result. Instead, before
opening a tray, disable the tray in the Printer Manager. After loading the
paper, enable the tray in the Printer Manager.
Performance capabilities
Performance capabilities for various paper types loaded in specific trays are
given in the chapter, Paper and other stock.
Loading paper in Trays 1-4
1. Pull out the paper tray.
Refer to the tray labels as you load the paper neatly in the tray. Make sure
that the left edge of the paper stack is against the bar that is located on
the left-hand edge of the tray, as shown in the top portion of Figure 1-6.
Do not load paper above the maximum fill line.
Figure 1-6. Loading Trays 1-4
2. Ensure that the paper tray edge guides are against the top, bottom, and
side edges of the paper. If the paper size is being changed, adjust the
guides as necessary, as shown in the bottom portion of Figure 1-6.
3. Push in the paper tray.
4. If the Printer Manager programming for the tray does not match the guide
settings, correct the programming. Refer to the DocuSP on-line help for
information on changing the programming.
Product overview
1-7