Xerox DocuPrint 65 Operator's Manual page 66

Paper and other stock
3-10
Table 3-6. Recommendations for loading special stock
Stock Type Common Use
Reinforced Mylar Ringed binders
edge
3 or 4 holes
Card stock Covers, signs
Tabs Separators within
a document
Transparencies Presentations
Labels Self-adhesive
labels for
envelopes and
packaging
Operator Guide
Recommendation
• Load reinforced edge on the
right in Trays 1-4.
• Load reinforced edge on the
left in Trays 5-6.
• Use long-edge feed only.
• Feed from the Bypass Tray for
best results.
• Use the Tab Tray insert.
• Feed from trays 2, 3, and 4
only.
• Load with the tabs on the right.
• Use clear or white-striped
transparencies. Do not use
paper-backed transparencies.
• Feed from the Bypass Tray
(Tray 5) preferred.
• Refer to the label on the tray
for the orientation of striped
transparencies.
• When using transparencies
with removable stripes, load
with the stripe up in Tray 5 and
the stripe down in Tray 1.
• Do not duplex.
• Do not duplex.
• Feed labels into the printer
LEF only.
Labels pose a special problem
because, depending on the
number of labels per sheet,
there is an opportunity for the
label to separate from the
backing while inside the
printer.
• Load face-up in Trays 1-4.
• Load face-down in Trays 5-6.
DocuTech 65/DocuPrint 65