Decurler Paper Path - Xerox DocuColor 7000AP Supplementary Manual

De c u r le r Ad j u s tm en t

Decurler Paper Path

2
With some print jobs, the output prints still may be curled more
than you desire even after using the Decurler Paper Type A-D
settings. In those cases, use the Decurler E Table Settings
feature to compensate for paper curl in your prints. The Decurler E
Table settings are based on job type and percentage of toner area
coverage. These settings are manually entered.
Table Settings" on page 8.
KEY POINT: If a Decurler profile setting is changed, it remains at
that setting until changed again manually. As an example, if you
decide to use the Paper Type B Decurler setting, the setting will
remain at Paper Type B until you change it to another setting.
KEY POINT: It is important to remember that a successful
Decurler setting used today may not be the same setting that you
would use on another day for the same file. This is especially
relevant if the room in which printer is located experiences
changes in temperature and humidity.
The Decurler has both upper and lower adjustment arms that
apply pressure to the paper based on system defaults, selections
made on the Decurler Setup screen (Paper Type A-D settings), or
based on entries made on the Decurler E Table Settings screen.
The degree of pressure is applied independently to the upward
and downward Decurler arms.
Do c uC ol o r 70 0 0A P / 80 00 A P De c ur l e r A dj u s tm en t
See "Decurler E