Setting The Apply Auto Trapping Option To On - EFI DocuColor 5000 User Manual

C S F
OLOR ETUP EATURES

Setting the Apply Auto Trapping option to On

When you select the Apply Auto Trapping option, you set the Printer's default value to On.
When you select Printer's default from the printer driver, the configured auto trapping is
applied to all jobs sent to the Fiery EXP8000/50.
Specifying Trap Width
Trap Width values determine how thick the trapped areas are. Specify the following values:
• Defines the horizontal thickness of the trapped areas (0-10 pixels).
Horizontal:
• Defines the vertical thickness of the trapped areas (0-10 pixels).
Vertical:
When you select the Uniform option, the horizontal and vertical Trap Width values are the
same. If the values were set before you selected Uniform, the higher of the two values is used
for both.
A small bitmap image in the lower-left corner of the Trap/Width pane provides a dynamic
visual example of the selected values.
Specifying Trap Color Reduction
Trap Color Reduction values determine how intense the trapping effect is. The values entered
reflect the percent reduction of the toner in the trap. You can enter values for the following
color channels:
• Defines the trap reduction in cyan (0-100%).
Cyan:
• Defines the trap reduction in magenta (0-100%).
Magenta:
• Defines the trap reduction in yellow (0-100%).
Yellow:
• Defines the trap reduction in black (0-100%).
Black:
A 100% reduction results in no toner intensity applied to the trap. A 0% reduction results in
full toner intensity.
When you select the Uniform option, all four Trap Color Reduction values are the same.
If the values were set before you selected Uniform, the highest value is used for all.
A small bitmap image to the left of each color in the Trap Color Reduction pane provides
dynamic visual examples of the selected values.
39