Changing The Roll Media Size And Type - Xerox 8850 Operator's Manual

MEDIA

Changing the roll media size and type

14
Whenever you open a media drawer, the message display
prompts you to change the type or width of the media. If you have
not changed the type or width of the roll media in the drawer, press
the Exit key. If you have changed the type or width, you must
enter the new information.
To change the roll media size and type:
1. Press the Media key. The message display indicates the
width and type of roll media last specified for drawer 1.
NOTE: The Media key is active from either on-line or off-line
mode.
2. Press the Previous or Next key to scroll through the media
source selections. The selections are ROLL1, ROLL2,
ROLL3, and BYPASS SHELF (cut sheet feed-in shelf).
3. When you scroll to the media source you want to change,
press the Enter key. The message display instructs you to
select the media width. It indicates the current media width.
NOTE: Media width does not apply to the BYPASS SHELF
selection. If you have selected BYPASS SHELF as the media
source, the message display instructs you to select the media
type. Proceed to step 6.
4. Press the Previous or Next key to scroll through the media
width selections. The width selections are:
11.0 INCH
12.0 INCH
17.0 INCH
18.0 INCH
22.0 INCH
24.0 INCH
30.0 INCH
34.0 INCH
36.0 INCH
5. When you scroll to the desired media width, press the Enter
key. The message display instructs you to select the media
type. It indicates the current media type.
XES SYNERGIX 8850 PRINTER OPERATOR MANUAL
297 MM.
353 MM.
420 MM.
500 MM.
594 MM.
620 MM.
707 MM.
750 MM.
841 MM.
860 MM.
880 MM.
900 MM.