Error Messages - Xerox 8850 Operator's Manual

Error messages

Error Message
CHECK FOLDER
FOLDER COMMUNICATIONS ERROR #17
F2-01 CHECK FOLDER
FOLDER COMMUNICATOINS ERROR #01
XES SYNERGIX 8850 PRINTER OPERATOR MANUAL
The error messages shown in the table below may appear on the
message display. Follow the instructions in the table before calling
for service.
Table 3. Error message table
Problem
FINISHER CONFIG TYPE
enabled, but no folder is
installed.
FINISHER CONFIG TYPE
enabled, but no folder is
installed.
PROBLEM SOLVING
Solution
1. Press the On-line/Off-line
key to take the printer off-
line.
2. Reset the value to NONE.
Refer to "Specifying the
finisher configuration
type" in this manual for
instructions.
1. Switch the printer Off.
2. Wait five seconds. Then
switch the printer On.
3. As soon as the Printer
Firmware Version
message is displayed,
press the On-line/Offline
key to take the printer off-
line.
4. Reset the value to NONE.
Refer to "Specifying the
finisher configuration
type" in this manual for
instructions.
43