Xerox 8850 Operator's Manual page 21

XES SYNERGIX 8850 PRINTER OPERATOR MANUAL
5. Rotate the media roll to wind the end of the media onto the
roll.
6. Lift the media roll out of the drawer.
7. Lay the media roll on a flat, horizontal surface.
8. Squeeze the lever at the end of the media roll support tube
and remove the tube from the media roll.
9. Lay the new media roll on a flat, horizontal surface.
10. Slide the end of the media roll support tube without the lever
into the new media roll as far as it will go.
MEDIA
11