Sun Ultra 60 Workstation - Xerox 4050 Installation Planning Manual

CONTROLLER COMPONENTS AND OPTIONS

Sun Ultra 60 workstation

2-4
Display monitor The display monitor has a 1192 x 700 pixel screen which displays the
IPS graphical user interface windows.
Keyboard The keyboard consists of alphanumeric keys similar to a typewriter,
symbols and special character keys, an extended character set, and
function keys. The keyboard is one of your main methods of
communicating with the printer. You can use the keyboard to make
selections, and to enter commands that control functions such as
requesting sample prints, obtaining billing meter totals, shutting down
the system, and so forth.
Mouse The mouse is another main method of communicating with the
printer. The mouse has three buttons. The left and right buttons are
used to select NPSIPS functions. The center button provides
additional functions that you will not be required to use. If your
workstation has an optical mouse, it must remain on its designated
metallic pad to be active. If the mouse has a roller ball instead of an
optical sensor underneath, it requires a non-metallic pad.
Note: Printer controller hardware configurations are subject to
upgrade.
The Sun Ultra 60 workstation provides a user interface to the print
engine. It has a high performance RISC processor chipset, based on
the industry standard Scalable Processor Architecture (SPARC). It is
used to operate the software that controls the printer. The
workstation contains the following hardware components:
•
•
•
•
•
•
Sun Ultra 60 workstation processor (system unit)
Display monitor
Keyboard and mouse
Diskette, CD-ROM, and cartridge tape drives
Connectivity board for Ethernet and, optionally, Token Ring
A Data Control Interface Module (PDCIMu) card installed in the
processor to interface with the print engine.
XEROX DOCUPRINT 4050/4090 IPS INSTALLATION PLANNING GUIDE