Xerox 4050 Installation Planning Manual page 114

DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
Item
description Default
FSSNAME None
JNAME None
JUNIT ON
MODE None
WC Any class
selected
WS
FSSDEF
DEVICE
E-6
Table E-3.
Source of value
Name of FSA in
JNAME parameter
FSSNAME parameter
of FSSDEF statement
See comments.
Must be FSS.
Installation output
class standards
Installation
preferences (see note)
Note: The WS parameter CL specifies that datasets with the
same class as the WS parameter should be selected. D
specifies that only datasets with the same destination as the
DGROUP parameter should be selected. F specifies that JES3
is to pass the forms value specified on the DD or OUTPUT JCL
statement to the FSA.
Following is an example of the JES3 initialization dataset
required commands:
Table E-4.
TYPE=WTR,FSSNAME=FSSTCP1,PNAME=FSSPROC1,SYSTEM=SYS1,TERM=NO
DTYPE=PRTAFT1,JNAME=PRT7,JUNIT=(,SYS1,,OFF),FSSNAME=FSSTCP1,
DGROUP=LOCAK, MODE=FSS,PM=(LINE,PAGE,SOSI1),WC=(T),WS=CL,D,F)
JES3 FSS statement parameters (continued)
Range of
acceptable values Comments
1 to 8-character Must match value in
alphanumeric string FSSNAME parameter of
FSSDEF statement.
1 to 8-character Must match value in
alphanumeric string FSSNAME parameter of
FSSDEF statement.
(Device address, Device address should not
Main, dest class, be specified for TCP/IP
ON/OFF) printers.
Main is name of processor
the FSS is to run on.
Dest class is destination
class for FSA messages.
ON or OFF specifies
whether FSA is initially
online or offline.
FSS MODE=FSS must be
specified.
List of If CLASS is specified in the
alphanumeric Work-selection criterion in
output classes, the WS parameter, the FSA
each separated by selects datasets that match
a comma values specified here.
Work-selection Consider CL, R, and F. See
criterion Note below and JES3
Initialization and Tuning
Reference manual for more
information.
JES3 initialization dataset commands example
XEROX DOCUPRINT 4050/4090 IPS INSTALLATION PLANNING GUIDE
Your value