Xerox 4050 Installation Planning Manual page 137

Configuration steps – OS/2
Configuration worksheet
Item description
Device Name
Device Description
Device Resolution
Attachment Type
IP Address
TCP/IP Port Number
Connect Timeout
Max Transmission Unit MTU
Queue Name
Queue Description
Device Busy Time
(Optional)
1. Configure the printer for TCP/IP in OS/2
2. Provide TCP/IP routing information if necessary
XEROX DOCUPRINT 4050/4090 IPS INSTALLATION PLANNING GUIDE
This section describes the process for configuring a TCP/IP attached
host computer with OS/2 to print on an IPDS printer such as your IPS.
The following worksheet will help you in planning the IPS installation.
It describes the key values which you need to supply when planning
the OS/2 configuration. All values on this worksheet must be
determined before you begin the printer configuration on the host.
Table E-23. OS/2 configuration worksheet for IPS
Also known as... Source
PSF/2 Control Panel—Define Device
PSF/2 Control Panel—Define Device
DPI, Pels per inch PSF/2 Control Panel—Define Device
Printer Protocol PSF/2 Control Panel—Define Device
TCP/IP Address Xerox NPS Printer software installation.
IPADDR PSF/2 Control Panel—Attachment Type
Settings
PORTNO IPS configuration Interface window and
subwindows
PSF/2 Control Panel—Attachment Type
Settings
Device Busy Time PSF/2 Control Panel—Define Device
OS/2 TCP/IP Configuration (TCPIPCFG)
Max packet size
Xerox NPS printer installation
MAXMTU
PSF/2 Control Panel—Define Queue
OS/2 Printer PSF/2 Control Panel—Define Device
Queue Name
Connect time-out PSF/2 Control Panel—Printer Definition
Configure your IPS for TCP/IP. (Refer to your IPS Guide to
Configuring and Managing the System, chapter 4, "Setting up the
Printer Controller."
TCP/IP routing information is needed for remote LAN configurations
only. (Refer to your host computer documentation for procedures, if
needed.)
DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
Your value
TCP/IP
E-29