Attaching Router To Mounting Plate - Grizzly T33850 Owner's Manual

Attaching Router to
Mounting Plate
Router attachment requires permanent
modification of router table mounting plate!
Before attaching router, thoroughly read
procedure below and make sure you can
perform required tasks.
Items Needed
Phillips Head Screwdriver #2 ............................ 1
Masking Tape or Marker .................... As Needed
Center Punch ..................................................... 1
Drill Press or Hand-Held Drill ............................ 1
Countersink Drill Bit ........................................... 1
The router mounting plate included with the
T33850 is designed to attach to the bottom of
your router in the same manner as the router
base. We recommend using the router base as
a template for the hole pattern to be drilled in the
mounting plate.
IMPORTANT: When deciding how to orient router
in relation to router table wing, consider access to
all router controls, adjustment knobs, lock levers,
and power switch.
To attach router to mounting plate:
DISCONNECT ROUTER FROM POWER!
1.
Mark front of mounting plate with tape or
2.
erasable marker.
Remove (2) Phillip head screws from mount-
3.
ing plate, lift mounting plate out of table open-
ing, and lay it bottom-side-up on a protected
working surface to prevent scratching top
surface of mounting plate.
Set router on
4.
Figure 17) and align spindle with center of
insert. Use marker to mark center curve of
router base, router base plate, and mounting
plate.
-14-
Qty
mounting plate (see
Note: Consider access to router controls
before finalizing router location. It may be
necessary to slightly adjust alignment if holes
in router base plate overlap or are too close
to starter pin holes.
Figure 17. Marking center of router base, router
base plate, and mounting plate with spindle.
Remove router base plate (see Figure 18).
5.
Note: Keep fasteners used to secure router
base plate.
Figure 18. Example of removing typical base
plate from router.
Model T33850 (Mfd. Since 08/23)
Spindle
Marks
Mounting Plate
Router
Base
Plate