Lifting & Placing; Bench Mounting - Grizzly G0950 Owner's Manual

Lifting & Placing
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
To lift and place machine on workbench:
1.
Using a forklift, move crate to machine work
site location.
2.
Remove crate top and sides, components
inside crate, and blocks around machine base.
3.
Remove fasteners securing machine to base.
4. Secure clamping leaf by inserting a wood 2x4
between clamping leaf and bending block
(see Figure 9).
Figure 9. Example of pan & box brake supported
by lifting straps and 2x4 to secure clamping leaf.
5.
Use forklift to raise machine, then place onto
workbench.
6.
Fasten machine to workbench following
instructions in Bench Mounting.
-12-
HEAVY LIFT!

Bench Mounting

Number of Mounting Holes ............................ 4
Diameter of Mounting Hardware Needed ..
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Figure 10. "Through Mount" setup.
Another option is a "direct mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Machine Base
Workbench
Figure 11. "Direct Mount" setup.
Model G0950 (Mfd. Since 08/21)
⁄ "
3
8
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Lag Screw
Flat Washer