Heating Devices; Defining The On/Off Heaters - Munters TRIO Installation Manual

the maximum to 8V the controller applies the calculated 0-100% output over
a 2V-8V signal.
o KWh: This field displays the amount of kilowatts used. Read-only.
7.3.3 H D
EATING EVICES

Define up to six relays and/or analogue output ports as heaters in Mapping , page
43.
o On-Off Fans
o 0 – 10 Volt Fans

7.3.3.1 Defining the On/Off Heaters

Define:
•
o Operation: Define the relay mode.
o Ignition Time (sec.): Define the delay time between when the heater is turned
on and when the gas is ignited.
o Test checks the relay functionality.
© Munters AB, 2020 57