7.5 Heating Devices
Define up to six relays and/or analogue output ports as heaters (refer to Mapping Devices,
page 50).
Defining the On/Off Heaters
•
Defining the Variable Heaters
•
7.5.1 D
O
EFINING THE
Define:
•
o Zone Heater:
Disable (default): Central Heaters, the heater output is related to the target
temperature, these heaters operate according to the average temperature (no
temperature sensors can be assign to it).
Enable: Zone Heater, the heater output has its own target set-point and its own
sensors assign to it. Zone heater will enable the assignment of temperature
sensor/s in temperature definition.
o Operation: Define the relay mode.
o Operation Modes
Continues (default): The heater start to operate continuously
Cycle: This option enables the operation of heater in cycles.
/O
H
N
FF
EATERS
© Munters AB, 2020
65