Heat Rejection - Follett Champion 7 Installation Manual

Water
WARNING!
Connect to potable water supply only.
§ Maximum total dissolved solids (TDS) 400 ppm. Ion exchange filtration or RO can reduce hardness.
§ Minimum TDS 10 ppm.
§ Maximum silica 20 mg/L. Reverse osmosis (RO) must be used to remove silica.
§ Maximum water hardness 100 ppm as CaCO3 (6 grains per gallon). Ion exchange filtration or RO can reduce
hardness.
§ Not recommended for use with sodium softened water
§ Ingress Protection (IP) rating: IPX0 (no protection)
§ Use provided water hardness test strips to verify incoming water hardness and adjust bypass setting on Claris
filter head (preinstalled behind front cover on most models). Refer to the below table for appropriate settings.
Adjust the bypass setting after completing the Internal Claris Filter Flushing Sequence section.
Hardness (ppm)
50
120
250
425
Note: Claris filter manifold is factory set at 3 prior to shipment.
Clearances
CI Models:
§
UD/UC Models: 2" (5.08 cm) behind dispenser for electrical and optional drain connection. 6" (15.3 cm) in
§
Electrical
115 V
§ 115 V, 60 Hz, 1 phase, 4A (hot water option: 8A), maximum fuse or breaker 15A
§ Connect to dedicated 15A circuit, fuse or breaker
§ Must be grounded - requires 3-prong outlet. Do not remove ground.
§ NEMA 5-15P 90 degree, 8' (2.4 m) cord supplied with machine
Refrigeration
WARNING!
Do not damage the refrigerant circuit. Refrigerant can cause personal injury and/or damage dispenser.
§ Refrigerant
– 115 V: R513a – 6.2 ounces (176 grams)

Heat Rejection

§ 1700 BTU/hr (498 W)
Setting
0
3" (7.62 cm) on each side of dispenser, 2" (5.08 cm) behind for electrical/water connection/
ventilation
front of dispenser for ventilation.
Interval (month)
6
5
3
2
0
Champion Dispenser and Ice Machine - 115 V
12
9
6
4
2
Gallons
1000
800
500
200
100
5