Required Tools/Hardware - Siemens SIMATIC NET RUGGEDCOM RST2228 Equipment Manual

Cable Type Wavelength (nm) Modal Bandwidth
a
Laser optimized.
1.5

Required tools/hardware

The following tools and hardware are required to install the device:
Tools
#1 Phillips screwdriver
Slotted screwdriver
Torx T10 screwdriver
10-18 AWG multipurpose crimping tool
Hardware
AC/DC power cord
Mounting brackets
M3-0.5 x 5 mm flat head screws
Pan head mounting screws
5 POS power terminal block plug
7 POS power terminal block plug
RUGGEDCOM RST2228
Equipment Manual, 10/2023, C79000-G8976-1359-19
(MHz·km)
1300 500
Tools
Tools
Distance (m)
100Base-FX 1000Base-SX
2000
Quantity
1 For removing/installing screw-type
terminal block plugs and the terminal
block cover.
1 For removing/installing European-style
(Euroblock) terminal block plugs.
1 For removing/installing modules.
1 For stripping and crimping wires.
Quantity
1 per power supply For connecting power to a power
supply .
#14 wire gauge is required.
4 Included with the device or available
as part of a separate mounting kit. For
more information, refer to "Parts and
accessories" (Page 14).
8 For securing the mounting brackets to
the device.
Included with the device or available
as part of a separate mounting kit. For
more information, refer to "Parts and
accessories" (Page 14).
8 For securing the mounting brackets to
the rack or panel.
1 For the failsafe alarm relay. The
device includes one European-style
(Euroblock) or screw-type terminal
block plug.
Additional plugs are also available for
purchase. For more information, refer
to "Parts and accessories" (Page 14).
1 For HI AC/DC or LO DC main power
connections. The device includes one
Introduction
1.5 Required tools/hardware
10GBase-SR
— —
Detail
Detail
13