Hayward HLXPLCONTROL Installation Manual page 6

Installing HLXPLCONTROL
DANGER of Death, Injury or Property Damage if procedure not followed. This equipment con-
nects to the OmniLogic panel beneath the dead front. Dead front removal is required for this instal-
lation. Power to the entire system MUST be shut off before the dead front is removed.
1. With the power removed, open the OmniLogic enclosure door and remove the dead front to
expose the OmniLogic Main Board.
2. Remove the existing Controller connection by unplugging its cable, then remove the cable
from the enclosure. Unfasten the existing Controller from its mounting surface. If the Control-
ler is connected to the home's access point via Ethernet, remove the connection.
3. Reverse steps 1-2 to install the new Controller.
5
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Controller 6 pin connector