Use Only Hayward Genuine Replacement Parts - Hayward HLXPLCONTROL Installation Manual

Load Clone onto New Controller
Out of the package, the new Controller will be set to factory defaults. In order to restore the original
configuration and settings, you will have to load the clone that was previously saved to the USB
thumb drive.
1. Insert the USB thumb drive into the USB port located on the bottom of the Controller.
2. Press the "OK" button and navigate to "Replace MSP".
Welcome to the Hayward Pool Controller
Press OK to con gure your pool.
OK
3. Press "Restore Clone from USB" and then select the clone file from the list. The file will be
named "Clone" followed by the MSPID of the previous system.
Clone Controller to USB
Restore Clone from USB
SYSTEM
Replace MSP
4. Wait for the system to finish restoring the clone. This may take a couple minutes depending
on the size of the configuration. Once it is complete, press the check mark and the system will
reboot.
5. When the system is done rebooting, verify that the configuration was loaded successfully and
there are no communication loss alarms. You are now finished replacing the OmniPL Controller.
3

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
en
datalog
Replace MSP
SYSTEM
con guration
select le
...\
USB/
Clone3233
MSP_AR_R0403000
WDT_AR_R0403000
Replace MSP
restore
2 / 2