Using The Chopper - BRAYER BR1257 Instruction Manual

8 EN
Notes:
- products should be put into the bowl before the
unit is switched on. The amount of products to be
processed should not exceed 2/3 of the capacity
of the bowl in which they are processed.
- before chopping and mixing peel the fruit, remove
inedible parts, such as stones, and cut fruit into
15x15x15 mm cubes. Put them into a bowl and
add some juice or water. The maximal amount of
products should not exceed 350 g and 250 ml of
water or juice.
- do not chop or mix frozen food.
ATTENTION! When chopping hard vegetables, for
example, car rots — cut the carrot into small 15x15x15
mm pieces and put them in the cup (11). The maximal
weight of the carrot should not exceed 150g. Add 250
ml of water.
• To switch the blender attachment (1) rotation off
release the button (3 or 4).
• After you finish the unit operation, take the power
plug out of the mains socket and remove the blender
attachment (1) by pressing the release buttons (2) .
ATTENTION!
- Do not remove the blender attachment (1) during
the unit operation.
- To avoid damaging the knives of the blender
attachment (1) do not process very hard products,
such as cereals, rice, coffee beans, hard cheese,
frozen food etc.
- If the foodstuffs are hard to chop with the blender
attachment (1), add some water, juice, liquor etc.

USING THE CHOPPER

Continuous operation time of the chopper
attachment should not exceed 30 seconds. Stop
using for at least 3 minutes between two operation
cycles.
• The attachment is used to chop meat, cheese, onion,
herbs, garlic, carrots, walnuts, prunes, vegetables
or fruit.
ATTENTION! Do not chop very hard products, such as
nutmegs, coffee beans, cereals, frozen food or ice.
PREPARING THE FOOD BEFORE CHOPPING:
• Remove bones, veins, cartilage and fat from meat.
• Cut meat, cheese, onions, vegetables or fruit into
pieces approximately 60x20x20 mm in size. Maximal
weight of the meat should not exceed 200 g.
• Remove stems of herbs, shell nuts.
CHOPPING
• Before assembling the chopper, make sure that the
power plug is not inserted into the mains socket.
• Place the chopper bowl (10) on a flat and steady
surface.
• Install the upper chopper knife onto the lower one
and turn it clockwise until bumping, install the knives
(9) on the axis inside the bowl (10). If there is a