Using The Chopper - BRAYER BR1248 Instruction Manual

8 EN
• Immerse the blender attachment (1) into the bowl
with food that you want to chop/mix; you can also put
the food in the measuring cup (11).
ATTENTION!
Hold the motor unit with the blender attachment (1)
vertically while processing the food (pic.1).
• To switch the unit on, press and hold down the button
(4) « ». Use this operation mode for mixing liquid
products.
• When you press and hold the button (4) « » you
can control the attachment rotation speed by turning
the control knob (5). Use this operation mode for
processing of liquid and solid products.
• For operation at the maximal rotation speed, press
and hold down the button (3) «T».
• Notes:
- products should be put into the bowl before the
unit is switched on. The amount of products to be
processed should not exceed 2/3 of the capacity
of the bowl in which they are processed.
- before chopping and mixing peel the fruit, remove
inedible parts, such as stones, and cut fruit into
15x15x15 mm cubes. Put them into a bowl and
add some juice or water. The maximal amount of
products should not exceed 350 g and 250 ml of
water or juice.
- do not chop or mix frozen food.
ATTENTION!
When chopping hard vegetables, for example, car-
rots — cut the carrot into small 15x15x15 mm pieces
and put them in the cup (11). The maximal weight
of the carrot should not exceed 150g. Add 250 ml of
water.
• To switch the blender attachment (1) rotation off
release the button (3 or 4).
• After you finish the unit operation, take the power
plug out of the mains socket and remove the blender
attachment (1) by pressing the release buttons (2)
(pic. 1).
ATTENTION!
- Do not remove the blender attachment (1)
during the unit operation.
- To avoid damaging the knives of the blender
attachment (1) do not process very hard
products, such as cereals, rice, coffee beans,
hard cheese, frozen food etc.
- If the foodstuffs are hard to chop with the
blender attachment (1), add some water, juice,
liquor etc.

USING THE CHOPPER

Continuous operation time should not exceed 10
seconds while using the chopper attachment. Make
at least 3 minutes break between the operation
cycles.