Changing The Digital Security Code; Installing The Beltclip - Uniden EXAI 398 Series Owner's Manual

EXAI398 12/26/2 10:33 AM Page 43
Turn on the answering system remotely
If you have forgotten to turn on your answering system, you can turn it on remotely from any
touch-tone telephone.
1) Call your telephone number.
2) Wait ten rings until the system answers. You hear a beep.
3) Press 0 and then enter your PIN code. The answering system announces the number of
messages stored in memory. You hear "To play incoming messages, press pound two. For help,
press pound zero".
4) Press 0 then 6 to turn the answering system On. You hear the outgoing message and a
confirmation tone.
5) Hang up the phone and subsequent calls will be answered by the system.

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base
unit. Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automatically set.
In the rare situation that you suspect another cordless telephone is using the same security code,
you can change the code.
1) Remove the handset from the base unit. Press and hold find hs on the base.
2) While the handset is emitting the paging sound, place the handset on the base unit holding
find hs. The paging sound stops. Leave the handset on the base for more than 3 seconds. A
new random security code is set.

Installing the Beltclip

To attach the beltclip
Insert the beltclip into the holes on each side
of the handset. Press down until it clicks.
www.uniden.com
To remove the beltclip
Pull both sides of the beltclip to release the
tabs from the holes.
T H E I N T E G R A T E D A N S W E R I N G D E V I C E
• To protect you against
misbilled calls which
might result from your
phone being activated
by other equipment, the
phone has AutoSecure TM
feature electronically
locks your phone when
the handset is in the
base. Also, the Random
Code TM digital security
which automatically
selects one of over
262,000 digital security
codes for the handset
and base.
• If the handset battery
pack is completely
discharged or the
battery pack is removed,
the digital security code
will be lost. If this
happens, a new security
code is set automatically
the next time the
battery pack is charged.
[ 43 ]